Service, in the
right order.
Scan, test, quote, then repair. Every job on this page follows the same sequence, whether it's a RM180 oil change or a gearbox rebuild.
Live data, not guesswork.Bay 03
No work starts without a written yes.
Scan first
A fault code is a clue, not a diagnosis. We test the circuit before quoting a part.
Price in writing
Parts, labour and time, sent on WhatsApp. The number doesn't move unless you approve it.
Parts shown
New boxes opened at the counter, old parts bagged and handed back. Every time.
Periodic maintenance
& oil service
Keep the logbook honest and the warranty intact. We service to the manufacturer interval, not to a generic sticker on the windscreen.
- Best for
- 10,000 km or 6-month intervals
- Parts
- Genuine or OEM equivalent
- Engine oil and oil filter
- Air filter and cabin filter
- Spark plugs at interval
- Brake, coolant and washer top-up
- 32-point visual inspection
- Tyre pressures and tread depth
- Service light reset
- Digital service record note
Bring your own oil if you prefer. We'll note the brand and spec on the job card and only charge for the filter, labour and disposal.
Computer diagnostics
& ECU scanning
For the warning light nobody can explain. We read every module, review freeze-frame data and test the wiring before condemning a sensor.
- Best for
- Check-engine, ABS, airbag, hybrid faults
- Output
- Written fault report + photos
- Full OBD2 and module scan
- Live data and freeze-frame review
- Visual inspection of the circuit
- Sensor and actuator testing
- Battery and charging test
- Fault code report explained
- Clear and re-test after repair
- Road test where relevant
We do not "delete the code and see how it goes". If we can't reproduce the fault, you leave with the scan data and no repair bill.
Brakes, suspension
& underbody
Vibration, knocking, pulling or a pedal that feels long. We measure the discs, load the suspension and show you exactly where the play is.
- Best for
- Noises, judder, uneven tyre wear
- Follow-up
- Alignment check after suspension work
- Brake pad and disc replacement
- Disc thickness and run-out measured
- Shock absorbers and mounts
- Lower arms and bushings
- Steering rack and tie rods
- Drive shaft and CV joint check
- Brake fluid condition test
- Full underbody inspection
We don't skim a disc that is already below the minimum thickness. If it's not safe, we'll say so and show you the measurement.
Aircond servicing
& cooling system
Cold air is a closed system, not a top-up. We recover the gas, find the leak and repair it before recharging — otherwise you'll be back in a month.
- Best for
- Weak cooling, smells, fogging, leaks
- Check
- Vent temperature before handover
- Leak test with UV dye and pressure
- Gas recovery and weighed recharge
- Compressor and clutch inspection
- Cooling coil and expansion valve
- Cabin filter replacement
- Aircond system flush (where required)
- Blower motor and resistor
- Radiator and coolant flush
- Condenser fan operation test
If the system is already empty, we will not just refill it. The leak test comes first, and the quote covers the repair, not a repeat visit.
Major overhaul
& transmission
When the engine or gearbox is the problem, guesses get expensive. Compression, leak-down and oil analysis first — then a staged repair plan with updates while it's on the lift.
- Best for
- Oil loss, smoke, slipping, overheating
- Approval
- Staged quote, no open-ended bill
- Compression and leak-down test
- Borescope cylinder inspection
- Top overhaul and gaskets
- Timing belt or chain service
- Clutch replacement
- ATF, CVT and DSG service
- Seal and leak repair
- Extended road test and re-scan
If a repair isn't worth it, we'll tell you before you spend. We'd rather lose the job than take a car apart for nothing.
Straight answers,
before you book.
Still deciding? Send the car model and the symptom on WhatsApp. You'll get a real answer, not a "come in and we'll see".
Ask on WhatsApp